This article contains the following sections:
1.Disassembly for Cleaning:
To ensure proper hygiene, it's essential to disassemble your M5 breast pump after each use for thorough cleaning.
| 1.First, hold the protruding parts on each side of the pump motor, then separate the pump motor from the milk collector. | |
| 2.Next, detach the flange from the milk collector. | |
| 3.Then, separate the valve from the flange. | |
| 4.Finally, remove the diaphragm from the milk collector. |
Important Caution: Never put the main unit, charging cable, or the adapter (if you've purchased one) in water or a dishwasher, as this will cause permanent damage to these parts.
2.Assembly for Use:
Before assembling, ensure all parts that come into contact with milk or your breast have been thoroughly cleaned and disinfected. Wait until disinfected parts have cooled down to prevent burns. Always wash your hands thoroughly with soap and water before touching breast pump parts and breasts to prevent contamination, and avoid touching the inside of the milk collection set.
Here are the assembly steps:
| 1.Wash your hands thoroughly with soap and water. | |
| 2.Attach the diaphragm to the milk collector and apply gentle pressure around the edge until the diaphragm seals well with the milk collector. | |
| 3.Gently push the valve into the flange, making sure there are no gaps. | |
| 4.Align the flange with the milk collector so the two patterns overlap, as shown in the picture. Ensure the flange fits securely around the rim by pressing it down with your thumbs. | |
| 5.Finally, attach the pump motor to the milk collector. |
Your breast pump is now ready for use!
