This article contains the following sections:
1.Disassembly for Cleaning:
To ensure proper hygiene, it's essential to disassemble your M6 breast pump after each use for thorough cleaning.
| 1.Hold the protruding parts, located on each side of the pump motor, then separate the pump motor from the milk collector | |
| 2.Detach the flange from the milk collector. | |
| 3.Separate the valve from the flange. | |
| 4.Remove the diaphragm from the flange. |
Important Caution: Never put the main unit, charging cable, or the adapter (if you've purchased one) in water or a dishwasher, as this will cause permanent damage to these parts.
2.Assembly for Use:
Before assembling, ensure all parts that come into contact with milk or your breast have been thoroughly cleaned and disinfected. Be careful, when you have disinfected the breast pump parts by boiling them, they can be very hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled down. Always wash your hands thoroughly with soap and water before touching breast pump parts and breasts to prevent contamination. Avoid touching the inside of milk collection set.
Here are the assembly steps:
| 1.Wash your hands thoroughly with soap and water. | |
| 2.Connect the diaphragm to the flange linker and apply gentle pressure around the edge until it seals well. | |
| 3.Push the valve into the flange, ensuring there are no gaps. | |
| 4.First, align the upper milk outlet, then press the edge of the flange with your palm to ensure a secure fit. | |
| 5.Attach the pump motor and milk collector. |
Your breast pump is now ready for use!
