This article contains the following sections:
1.Disassembly for Cleaning:
To ensure proper hygiene, it's essential to disassemble your Air1 breast pump after each use for thorough cleaning.
| 1.Detach the flange from the pump. | |
| 2.Grip the protrusions to detach the milk collector from the main unit. |
|
| 3.Remove the diaphragm from the milk collector. | |
| 4.Disassemble the milk collector. | |
| 5.Disassemble the milk collector. |
Important Caution: Never put the main unit, charging cable, or the adapter (if you've purchased one) in water or a dishwasher, as this will cause permanent damage to these parts.
2.Assembly for Use:
Before assembling, ensure all parts that come into contact with milk or your breast have been thoroughly cleaned and disinfected. Be careful, when you have disinfected the breast pump parts by boiling them, they can be very hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled down. Always wash your hands thoroughly with soap and water before you touch breast pump parts and breasts to prevent contamination. Avoid touching the inside of milk collection set.
Here are the assembly steps:
| 1.Wash your hands thoroughly with soap and water. | |
| 2.Gently push the valve into the milk collector, making sure that no gaps remain. | |
| 3.Assemble the milk collector. | |
| 4.Attach the diaphragm to the milk collector and secure the lid to form a tight seal. | |
| 5.Holding the two edge protrusions, attach the collector to the main unit. | |
| 6.Install the flange. |
Your breast pump is now ready for use!
