This article contains the following sections:
1.Disassembly for Cleaning:
To ensure proper hygiene, it's essential to disassemble your V1 Pro breast pump after each use for thorough cleaning.
| 1.Separate the tubing from the pump. | |
| 2.Separate the tubing from the milk collector. | |
| 3.Detach the flange from the milk collector. | |
| 4.Separate the valve from the milk collector. |
Important Caution: Never put the main unit, charging cable, or the adapter (if you've purchased one) in water or a dishwasher, as this will cause permanent damage to these parts.
2.Assembly for Use:
Before assembling, ensure all parts that come into contact with milk or your breast have been thoroughly cleaned and disinfected. Be careful, when you have disinfected the breast pump parts by boiling them, they can be very hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled down. Always wash your hands thoroughly with soap and water before you touch breast pump parts and breasts to prevent contamination. Avoid touching the inside of milk collection set.
Here are the assembly steps:
| 1.Wash your hands thoroughly with soap and water. | |
| 2.Gently push the valve into the milk collector. Make sure there are no gaps. | |
| 3.Align the flange with the milk collector as shown in the picture, then push the flange tunnel inwards. Make sure the flange fits securely around the rim by pressing it down with your thumbs. |
|
| 4.Attach the diaphragm with the milk collector and secure the lid to form a tight seal. | |
| 5.Connect the long end of the tubing to the pump motor. |
Your breast pump is now ready for use!
