After completing each step, check that fixing is secure!
Fixing in certain position is most of the times acccompanied with a click!
Make sure all pins have shown through the openings.
1.How To Install The Base
Connect two base tubes together as per Fig.1-1 until thee shrapnel pops out.
2.How To Assemble the Seat Connector
Place the installed base on the ground, and insert the seat cconnector into the base as per Fig.2-1 until the axle gets lock in the base and cannot be pulled out upwards.(Fig.2-2)
3.How To Assemble the Seat Frame
Connect to backrest tube with the seat tube as per Fig.3-1,make sure the sharpel pops out, then assemble the seat frame into the base as per Fig.3-3 till you a "click" sound, make sure both backrest tube and seat frame cannot pull out.
4.How To Assemble the Engine Machine
Put the top of the engine machine into the head of the seat first till the shrapnel pops out as per Fig.4-1, and put the tube into the base till the shrapnel pop out as per Fig.4-3
5.How To Assemble the Seat Cover
Put the seat cover on the seat tube from bottom to top,wrap the entire software on the seat tube as per Fig.5-1, then zip up the back to secure the seat fabric as per Fig.5-2 and Fig.5-3
6.How to Assemble the Toybar
Buckle the left and right sides of the toy stick onto the seat tube As per Fig. 6-1.
