[Article Navigation]
1. Aspirator Installation and Operation
2. Spray Function Installation and Operation
3. Cleaning and Disinfecting Instruction
1. Aspirator Installation and Operation
1.1 Choose the appropriate size tip based on the anticipated use.
Picture |
Tip |
Suggestions for use |
Depth |
Gourd Shape Tip |
Safe and prevent inserting deep into the nostrils design |
Shallow |
|
Long Tip |
Recommended for use when mucus is thinner |
Deep |
1.2 Attached the selected tip firmly to the aspirator unit; it should fit flush against the unit housing.
1.3 Press the switch button to activate the aspirator and ensure it is operating correctly before placing into the nostril. The device will continue to suction for five minute and stops automatically.
1.4 Place the silicone tip into children’s nostril and use suction to remove mucus. Repeat in the other nostril as needed. If the children feel uncomfortable, please stop using it immediately. For example, crying, screaming, difficulty breathing, intense reactions, apnea, cyanosis, etc.
1.5 The correct way to inhale your nose is as shown below:
Note: It is normal for the snot chamber to overflow from the small opening when it is full, reminding the consumer that the liquid is full and needs to be cleaned.
1.6 Prohibited use:
Note:
a. This mucus may not immediately be visible in the collection reservoir. It is recommended that the silicone tip and aspirator head be removed and rinsed between each use to keep any mucus from drying and clogging the device.
b. Be careful not to place the tip too far into the nostril or press against the inside wall of the nostril. Excessive use of this device may result in pain, mucosal injury or respiratory distress in some circumstances.
c. Excessive use of this device may result in pain, mucosal injury or respiratory distress in some circumstances.
2. Spray Function Installation and operation
a)Before use, remove and wash the sprayer module, pour water or saline into it, and install it on the unit.
b)Press the spray button to start.
c)To stop the sprayer, press the button again.
Note: The sprayer will stop after 6 seconds. It will also stop when the battery voltage is too low.
| Button Operation |
|
3. Cleaning and Disinfecting Instruction
The following cleaning procedures should be performed after each use. Failure to clean equipment properly can cause clogs and shorten product life. The device should not be reused until thoroughly cleaned.
3.1 Carefully separate the tip and sprayer module from the unit.
3.2 Unscrew the collection cup from the head module.
3.3 It is suggested that the rubber seal inside the module head be removed for cleaning and ensure the unit is fully dry before use, preventing the growth of bacteria.
3.4 It is recommended that the silicone tip and collection cup be at minimum rinsed well with hot water between uses to prevent mucus from drying and clogging the unit.
3.5 When the liquid does not overflow from the small hole on the side, remove the nasal suction head and the snot chamber for cleaning.
When the liquid in the collection cup exceeds 2/3 of its capacity, it may overflow from the side hole as an indicator (this is normal). Please empty and clean the cup immediately to prevent back-flow and contamination of the device.
5.6 Do not wash or immerse the housing body of the aspirator. Use a soft, dry cloth to clean nasal aspirator. Never use abrasive cleaning agents, thinners or benzene for cleaning.
5.7 Do not expose the nasal aspirator to extreme temperatures, high humidity, direct sunlight, or shock.
5.8 Allow all pieces to dry completely before reassembly.
5.9 After completing the cleaning steps, visually inspect to ensure it is clean. If there is visible dirt on the device, repeat the cleaning steps until it appears clean.
Note: Protect the nasal aspirator from mechanical shock or heavy impact. Store the unit in an area away from sunlight, dust and humidity.