"Auto" Mode
1. Plug in the appliance.
2. Pour the rated water amount of120ml/4oz on the heater surface.
3. Press the "On/Off" button briefly to turn on the appliance.
4. Press the "Mode" button to select "AUTO" mode
with this icon flashing with a white LED.
5. The appliance will start its Auto cycle in3 seconds after the mode has been selected. When the cycle starts, the LED light will switch to a constant white LED from a flashing white LED light.
6. Upon the completion of the Auto cycle, the appliance will switch to "Storage" mode automatically without beeping.
Notes:
1. The default Auto mode cycle is35 minutes, including Sterilization for8 minutes and Drying for27 minutes.
2. When Auto mode is in use, the Drying duration can be increased in15-minute increments by long pressing the "Mode" button for2 seconds.
Caution: Steam and hot air escaping from the appliance can cause burns. Always allow5 minutes to cool down after the cycle is finished before lifting the lid.
"Sterilization Only" Mode
1. Plug in the appliance.
2. Pour the rated water amount of120ml/4oz on the heater surface.
3. Press the "On/Off" button briefly to turn on the appliance.
4. Press the "Mode" button to select the
"Sterilization Only" mode. The icon will then flash with a white LED.
5. The appliance will start its Sterilization cycle in3 seconds after this mode has been selected. When the cycle starts, the icon will switch to a constant white LED from a flashing white LED.
6. Upon the completion of the Sterilization cycle, the appliance will automatically turn off without any LEDs.
"Drying Only" Mode
1. Plug in the appliance.
2. Do not pour any water on the heater surface.
3. Press the "On/Off" button briefly to turn on the appliance.
4. Press the "Mode" buttonto select "Drying Only" mode
. The icon will then flash with a white LED.
5. The appliance will start its Drying cycle in3 seconds after this mode is selected. When the cycle starts, the icon will switch to a solid white LED from a flashing white LED.
6. Upon the completion of the Drying cycle, the appliance will switch to "Storage" mode automatically without beeping.
Notes: The default Drying cycle is30 minutes, during which time, the Drying duration can be increased in15-minute increments by long pressing the "Mode" button for2 seconds.
Caution: Hot air escaping from the appliance can cause burns. Always allow5 minutes to cool down after the cycle is finished before lifting the lid.
"Storage" Mode
1. Plug in the appliance.
2. There is no need to pour any water on the heater surface.
3. Press the "On/Off" button briefly to turn on the appliance.
4. Press the "Mode" button to select "Storage" mode
". The icon will then flash with a white LED.
5. The appliance will start its Storage cycle in3 seconds after the mode is selected. When the cycle starts, the icon will switch to a constant white LED from a flashing white LED.
6.The default Storage duration is 72 hours. The appliance will activate the Drying process for5 minutes every 55 minutes, which means the Storage process will be performed hourly.