Navigation: Auto-Lock Function - Reset and Tare Functions - Unit Conversion - Overload Indication - Low Power Indition - Weighing in Mother Mode
Auto-Lock Function
While the scale is performing a measurement, do not remove the baby from the tray, as it will auto-lock after 2s to capture the baby’s weight.
Reset and Tare Functions
A. Short-press "TARE" if you need to place a towel/cloth on the tray before placing the baby in it. Pressing "TARE" after placing a towel/cloth in the tray will reset the scale and cause the readout to display “0.000.” You may then place the baby on top of the towel/cloth in the tray and calculate the baby’s weight.
B. If the Auto-lock function has already captured your baby’s weight, but need to weigh another baby, simply short-press the "TARE" button until the readout displays "0.000" and then weigh the baby (this function can be repeated as needed).
Unit Conversion
Press the "UNIT" button to toggle between "kg," "g," "oz," "lb," and "lb:oz"
Overload Indication
If the weight exceeds the scale's rated maximum capacity, the LCD display will show an "Err" message.
Low Power Indication
When the LCD display shows a "Lo" message, please replace the batteries with new batteries, ensuring the batteries are aligned properly (correct polarity).
After 120s of inactivity, the scale will automatically shut off.
Weighing in Mother Mode
Please ensure the scale is used on a hard and flat surface;
Remove the removable tray upwards.
Long-press the "UNIT" button to toggle the orientation of the display readout, as shown in the figure.
Stand erect on the scale's surface to obtain a weight measurement.
