The theme of this article is the instruction for use of Momcozy Wellness 1 wearable breast pump.
This article contains the following sections:
1. Preparations before pumping
1. Preparations before pumping
please refer to:Preparations before pumping
2. Assembling the Pump
- Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk or breast.
please refer to：Cleaning and Disinfection of Wellness 1 Breast Pump - only start assembling the breast pump when disinfected parts have cooled down.
- Wash your hands before you touch breast pump parts and breasts to prevent contamination. Avoid touching the inside of milk collection set.
assembling the pump,please refer to:Disassembly and Installation of Wellness 1 breast pump
3. Pumping instructions
- Before you remove the pump body from your breast, always switch off the breast pump to release the vacuum.
- Do not continue pumping for more than 5 minutes at a time if you do not succeed in expressing any milk. Try to express at another time during the day.
- If the process becomes very uncomfortable or painful, stop using the pump and consult your healthcare professional.
- Monitoring milk level during pumping to ensure overfill does not occur.
1)Alignment
a. Before pumping, please make sure the pump is pressed tightly on your breast without a gap.
b. To align, hold the flange against your breast so you can see if your nipple is centered in the flange tunnel. You may need to bend forward.
c. After you've aligned, look through the flange to confirm your nipple is centered before pumping. The tip of your nipple should NOT touch the top,sides or bottom of the flange tunnel. If it does, try again.
2)Secure Pump in Bra
Secure Pump in place by bra, taking care to keep Pump pressed firmly against breast. If necessary, tighten bra to keep Pump securely in place and start pump.
3)Starting pumping
- Do not slide pump directly into your bra, follow step-by-step instructions.
- Disconnect from Charger before use.
| A. Turn on the pump |
|
| B. Select the mode | Modes: Stimulation Mode & Expression Mode & Mixed Mode& Milk Boost Mode When you first use the pump,the default setting is suction level 1 of stimulation mode. You can also select a personalized mode. |
| C.Select the vacuum level |
Momcozy pump has 12 vacuum pressure settings for each mode, giving you control over what feels comfortable and works most efficiently in all modes. Once you feel uncomfortable, use the Increase / Decrease button to adjust the vacuum pressure. Always ensure you are pumping at a comfortable level. |
Tips:
1.A higher vacuum pressure does not always mean a higher volume of milk.
2. Always ensure you are pumping at a comfortablle level. If you don't feel suction, please check the pump is assembled correctly.
3.Warm / Massage will not start if the flange is not installed properly.
4)Remove the pump
- Use your finger to break the seal between the flange and the breast tissue.
- Lean slightly forward to remove the pump from the breast after your pumping session, then keep the flange opening side up to prevent milk from pouring over.
Caution:
- Momcozy pump does not support use while charging. Always disconnect from the charger and close the charging cap before use.
- Momcozy pump should not be used while lying down, engaging in strenuous activities or performing activities with risk of harm.
- Using a breast pump should not cause pain. Do not try to express with a vacuum pressure setting that is too high or uncomfortable. If excessive discomfort or pain is felt during pumping, stop pumping,break the seal around your nipple and discontinue the session.
